Identify the thread and the seal
Identify the thread and where the connection seals before ordering a hose fitting. Matching a nominal size is only a starting point.
Swagelok's identification guide treats thread form and end connection as separate questions: the latter includes the sealing area and geometry. A thread designation alone is an incomplete order.
Record more than one diameter
The guide considers male or female threads, straight or tapered form, diameter and pitch, then the end connection. Record the units: metric spacing and threads per inch differ.
Basic measurements can leave ambiguity. Swagelok warns that 1/2-inch and 3/4-inch BSPT and NPT can need specialized inspection to distinguish. A close measurement does not establish interchangeability.
What an M22 label can leave out
BE Power Equipment's April 2022 bulletin TB10002 covers listed Workshop electric models, including P1415EN and P2014EN. It describes a 22 mm outside thread dimension with a 15 mm inside pilot, compared with 14 mm for the other BE screw-together connections addressed by the bulletin.
The bulletin gives different instructions for replacing a hose and extending one. This is a model-specific example, not a compatibility rule for every electric or gas washer. Confirm the exact machine and current replacement information with BE before choosing parts.
Send the supplier a clear request
Our suggested record: machine model, hose and accessory part numbers, markings and photographs of both connection ends. State whether you are replacing the hose or adding an extension. Include the operating pressure, flow, fluid, temperature and proposed hose length. Ask the supplier to identify the matching connection and document the complete assembly's suitability.
Identification does not establish operating suitability
Connection identification is only one selection step. Swagelok also calls for considering system design, material compatibility, ratings and installation.
BE's P2115EN manual warns that pressure can remain after switching off and prohibits disconnecting the high-pressure hose while the system is pressurized. Follow the shutdown and pressure-relief instructions for your exact equipment before examining connections; this example does not replace them.
Sources & references
- Thread and End Connection Identification Guide, MS-13-77 Rev. H, February 2025 — Swagelok. Checked November 15, 2026.
- M22 Connections for Workshop Series Electric Pressure Washers, TB10002, April 2022 — BE Power Equipment. Checked November 15, 2026.
- P2115EN Operator's Manual, 96397-LJ, December 2021 — BE Power Equipment. Checked November 15, 2026.
